Subaru Community

Your still up front Matt!. Voted again for you, good luck mate.

Thanks Lee! It got close last night, only 0.09% in it at one point!

Really need to get as many votes as poss!

and happy birthday once again! :-D

Hi Guys, these are the pics which I submitted BTW, these will all be in the mag when it comes out. I’ve attached my Spec list below too if anyone is interested?



Please Vote - Car 7 - Matt Johnson! http://www.totalcarmagazines.co.uk/idol-…-FINAL-2010.htm











Engine Internal:
2.15ltr Stroker kit 8.4:1 CR
Closed Deck Block
Under piston oil jets
Bored and rehoned to 92.5mm
Modified oil ways
2.5 STi 79mm cross drilled nitride crank
Mahle 2618 race material lower deck stroker pistons
Mahle piston rings and gudgeon pins
14mm head stud converted
14mm ARP head bolt set Rear thrust converted
Manley steel H section rods
ARP2000 rod bolts
ACL full RACE bearing set
0.6mm 3 layer Cometic head gaskets


Engine External / Ancillaries:
Lateral Performance MD321T Turbo w 76mm Inlet
Lateral Performance turbo fitting kit
Lateral Performance custom 76mm inlet hose with breather blocked off
Syvecs ECU c/w Wideband control & Calibration switch
Nismo 740cc flow matched injectors
Fuel lab fuel pressure regulator c/w pressure gauge
Bespoke made parallel stainless braided fuel rails
Bespoke made stainless braided fuel lines
Systec Billet fuel filter
Walbro 290 High Flow Fuel Pump
SETRAB 26 row Oil Cooler with bespoke made stainless braided lines
Mocal Themostatic Plate
RCM Nickel plated light-weight pulleys
RCM 12mm modified high flow oil pump
RCM Oil catch tank
RCM billet timing belt guide
RCM 3" gas flowed down pipe
RCM Hi Flow Induction
RCM 80mm Induction Trumpet
102mm bore cold air feed through headlight
HKS 3” Hi-Power Strait through Centre pipe
HKS 3” Hi-Power back box
GT spec Gen II FMIC
GT spec Gen II Tubular unequal length headers
Harvey Smith Custom up-pipe
Cosworth sump baffle
Group N Engine mounts
3 Bar MAP sensor
3 port boost control solenoid
Headers DEI Titanium heat-wrapped
Up-pipe DEI Titanium heat-wrapped
Downpipe DEI Titanium heat-wrapped
Exedy Single Plate Organic Clutch
Fidanza 4.4kg Lightweight Flywheel
NGK PFR7B spark plugs gapped to 0.6
Ported throttle body,
Insulating manifold spacers
Header tank spacers
J Performance High capacity Aluminium Radiator
Prodrive Slam Panel
Full Samco setup
Heavy Duty Battery
Hot coolant throttle body bypass
PowerFlex Polyurethane Exhaust Hangers
Magnecor HT Leads
71 degree thermostat
HKS LTD Ed. 1.1 header tank cap
HKS LTD Ed. Billet oil filler cap
Dump valve blocked off


Handling:
Prodrive Alcon 330mm Brake Upgrade
330mm Godspeed Rotors
316mm rear Brembo 2pot conversion
Whiteline 22mm adjustable ARB
Whiteline rear Droplinks
Whiteline front sway bar bushes
Whiteline steering rack bushes
Whiteline front anti-lift kit
Harness Support Bar
Sabelt Harnesses
PowerFlex Wishbone Bushes
Prodrive geometry Stage 1 fast road setup
Anodised blue split bells
F+R Braided Hoses
Ferodo DS2500 Pads
Goodyear Eagle F1 tyres


Interior:
Defi-Link white face Gauges
Remote knocklink display mounted in clocks
Prodrive Gear Surround
Sabelt Harnesses
Harness Suport Bar
Tyre Pressure and Temp monitor
Bespoke made Carbon dash on the way!
STi Electric Folding Mirrors
STI pedals
STi Door Sills
P1 Plaque
Prodrive Gear knob
Prodrive Mats inc Boot mat


Exterior / Styling:
74F P1 Blue Painted bonnet (underside)
74F P1 Blue rocker covers
74F P1 Blue timing belt cover
74F P1 Blue fan shroud
74F P1 Blue centre band on alternator
Polished alternator casing
Powder coated FMIC pipes
Custom powder-coated header tank
Custom powder-coated Power steering tank
Painted / powder-coated brackets
Bespoke made Carbon inner wing plate
Colour coded performance hoses
All nuts and bolts replaced for stainless options
Tein Bonnet Dampers
Custom Grille badge
D1 Spec lightweight wheel nuts
22b bonnet vent
Induction scoop (air guided)
HID Conversion
LED sidelights and number plate lights
Front quad Lights
Rear STi Lights
Crystal Pack
Personalised Plates
Tinted windows
Prodrive Battery Clamp
Subaru Colour Coded Side Protectors
Shark’s Fin Arial
Iridium Effect Indicator Bulbs Rear
Silver Tech Bulbs Front

Zitat von »creative«

würde ja auch gern öfter abstimmen, aber bei mir klappt das nicht...habe vor ein paar Tagen einmal abstimmen können, und seitdem sagt der mir immer, dass ich schon gevoted hab....

Weiß jemand abhilfe?

In den letzten vier Runden konnte man Abstimmung alle 15 Tage. Für die endgültige Sie können nur einmal wählen aus jedem Computer oder IP-Adresse!

(Sorry für durch schlechtes Deutsch!)

Zitat von »Spooky«

Zitat von »creative«

würde ja auch gern öfter abstimmen, aber bei mir klappt das nicht...habe vor ein paar Tagen einmal abstimmen können, und seitdem sagt der mir immer, dass ich schon gevoted hab....

Weiß jemand abhilfe?

In den letzten vier Runden konnte man Abstimmung alle 15 Tage. Für die endgültige Sie können nur einmal wählen aus jedem Computer oder IP-Adresse!

(Sorry für durch schlechtes Deutsch!)

@ Creative: du müsstest eine neue IP-Adresse ordern, geht bei dir eventuell wenn du dein Modem für 10sec ausschaltest ( so klappts bei mir.. Keine Haftung für Folgeschäden xD)

@ Spooky: No Problem, our english is sometimes under all pig

Loos Votet... er liegt ja 1.06% zurück.. das sollte man ändern oder?

Thanks guys! Please keep the votes coming, its getting very close!!

habe stimme auch abgegen ..... und zwar für chris buckler, sein wr rockt

wieder gevotet, jetzt hat er Vorsprung

Thanks guys! i'm back in the lead now :-D!!!!

Thanks to your support! Please keep the votes coming, you can vote every 15 days so you can vote twice!!

0.77% in Führung.