How to solve the car overheating?
1, when the water
table to display your car is overheating recent drive to a safe place. Turn off
the engine, open the hood, so that as much heat to escape. Turn the ignition to
make your heating system work. Open the heat and blower a few minutes to
disperse from the engine system more calories. Do not pour cold water engine
and let it cool down slowly.
2. Check the radiator
tank engine coolant level, if the level is low, turn on the engine coolant tank
cap and fill the coolant. If you do not have any engine coolant, you can also
use cold water. To give into the radiator coolant or water circulation systems,
etc. After it was cooled engine start with Legacy
rods, keep the engine running to keep neutral.
Fill more coolant or
water into the tank until it reaches the "hot" sign. Engine shut-off
valve cap and observe the thermometer a few minutes idling. If the engine does
not overheat, and you can safely drive. If you are using water to fill, you
should drive to the nearest service station, and replacing some of the water in
the radiator to the engine coolant.
3, after the addition
of the new coolant or water-cooled watch thermometer. If you exceed the safety
limit mark a rebound after a few seconds to a safe temperature zones is also
possible. This means that your thermostat is working properly. However, if the
engine is overheated more than 30 seconds, and immediately close it. Do not try
to drive the car to the nearest repair overheat station to replace the
thermostat, which is an inexpensive and quick maintenance work, almost any
mechanic can do.
Forester Forum »
The 2012 production of forest engine there is no lubricating oil consumption
(19. Mai 2012, 17:48)
Montag, 20. Oktober 2025, 11:46
Zum Seitenanfang
